溶解式粗糙機

◆設備特征 Product features

※具備有保持穩定不一樣的撒氣壓力差和露點

1.氣味吸附塔之高寬比與直徑怎么算經實驗所效果精密儀器計算，塔床進而導致阻力小，提高了壓縮視頻氣味變干劑5秒的學習時光，考慮產品氣的露點規定要求。

2.30％的烘干處理劑空間，在賠賞烘干處理劑的自然而然脆化，提高認識烘干處理。

3.大形擴撒器，保持氣體流動粗糙采用非常干燥劑層，解決溝流現像。

※重復氣量衰減少于14％

1.優異的機筒設計的，永久保存100％的離心分離卡路里，儲放的卡路里適用于曾加重復利用環節的重復利用氣溫濕度，提生裝置的解吸業務能力，因此重復利用更齊全。

2.干熱和降解主要包括交叉熱對流計劃書，濕空氣中穿過干的粘附劑時長果極佳。降解氣進口含濕量掌握在亞飽合程序，使消音器原理器及改裝排氣管綠色通道無結霜現象之慮。

3.可選擇干澀機的使用過載消費需求改善凈化氣使用，為了確保凈化氣旋累計保持穩定，凈化壓低至臨界點。

※干燥的劑利用壽命短長

1.最合適的機筒長寬高，使氣體利用干劑層的空氣流速和用時要保持好的方式，足夠發揮出干劑的能。

2.科學合理的軟件調試，在熱空氣進到機筒前，經除油補救按時除掉熱空氣中內含油量物與重環境污物，杜絕皮膚干燥劑層受環境被污染。

※專用設備選擇了刺激高品味電動四輪及氣動系統閥和穩定可靠的全電子技術可源程序序掌握器，電腦接口和睦，半自動重復呈現雙塔工況法，循環往復定期實地現場可編，出產設置10min。閥體人類壽命歷時50萬次行為。

※壓力容器封頭內壁上作冷電鍍鋅防生銹工作，10年不銹跡。

※行為正確、性能參數不穩、實際操作方便，安裝不要基本。

※Bend it out on the same has the stable pressure and dew point

1. The height and diameter adsorption tower by the experimental results calculated precisely, tower, ensure the small resistance bed compressed gas desiccant 5 seconds contact time, meet the requirements of the finished product angry dew point.

2.30% of the surplus, desiccant used to compensate for the natural aging, ensure desiccant dry.

3. Large diffuser, ensure uniform through the desiccant air layer, eliminate channel flow phenomenon.

※Bend the gas loss less than 14% renewable

1. Excellent barrel design, save 100% of the adsorption quantity of heat, storage quantity of heat is used to increase the regeneration stage again angry temperature, improve equipment desorption ability, make renewable more thoroughly.

2. Dry and regeneration of the reverse convection scheme, wet air through the dry when the adsorbent best effect. Getting angry export moisture content control in the saturated state, the muffler and exhaust passage without concentrations of condensation.

3. According to the operation of the dryer load demand adjust dosage, ensure again angry for stability, regeneration renewable air pressure low to critical.

※Bend desiccant long service life

1. The right of barrel size, make the gas through the desiccant flow velocity and time of layer be the best, give full play to the desiccant performance.

2. The reasonable system configuration, in the air into the barrel, except by the efficient before oil processing timely removal in the air in content and heavy oil pollutant, avoid desiccant layer contamination.

※The equipment adopts bend novel high quality and pneumatic valve electric and advanced and reliable full electronic programmable controller, friendly interface, automatic continuous display of the twin towers, working cycle, the programmable factory set 10 min. The valve life for 500000 times action.

※Bend the cylinder body wall be cold galvanizing antirust processing, 10 years don't rust.

※Bend action, stable performance, accurate, easy operation and installation with no need of foundation.

◆主耍技術規格 Main technical parameters